INSTALLATION OF SECURITY SHIELDS

1. Wrap the safety spray shield tightly around the flange, valve or fitting.
2. Press the two portions of the velcro fastener together to close the shield.
3. Pull the tie cords together tightly on each side, take one or two turns around the pipe and fasten over the pipe with a square knot. In the event of a leak, a square knot tightens when subjected to pressure, avoiding the risk that the shield loosens and slides off the fitting or valve. If incorrectly tied, a granny knot results and under pressure, this knot becomes untied allowing the shield to be ineffective in preventing a sprayout.
4. Do not cut the tie cords but tuck them between the flange and shield.

Please request exclusive video for the Installation of “Metal Shields”

INSTALLATION MANUAL